New Unity changes on Staging - question on how to load a level

[Const1702]

Question:
How do I get the composites to load in the viewer using the latest Staging version of OpenCAGE?

OpenCAGE version: 0.13.1.327 (Staging):
Downloaded the newest version of Unity as ZIP from the LevelViewer repo, Staging branch. When I open Unity it says this:

"Connect to Unity" is enabled and I also see Level Loader in the sidebar but that's it. Nothing else loads but there is also no error. I tried to stop and then click "Play" in Unity but I just get the two messages in console.

Switched to Master branch.
OpenCAGE version: 0.13.1.2 (Master):
Additional messages show about the composite and it actually loads properly:

In both versions of OpenCAGE (Master and Staging), the LevelViewer is using its latest Staging version.

I'm most likely missing some steps after the update as there aren't any errors.

Unity version:
2022.3.9f1.0.16527
Revision: 2022.3/staging ea401c316338
Built: Thu, 24 Aug 2023 11:00:42 GMT

[Const1702]

Just figured it out!

In both versions of OpenCAGE (Master and Staging), the LevelViewer is using its latest Staging version.
Here I thought I was using LevelViewer Staging but remembered that instead of manually copying the resources with their dependencies I used commandline, which cloned the repo from its Master branch.

I manually installed the Staging one and copied the sub-modules (CathodeLib then AlienBML) and it is working! Sorry for inconvenience!

[MattFiler]

Hey - you don't actually need to do this manual cloning process anymore. The Level Viewer is included with OpenCAGE to keep things nicely in-sync with the Commands Editor.

Just open Unity Hub, select "Add" then "Add project from disk", navigate to your Alien: Isolation folder and select the folder "DATA/MODTOOLS/REMOTE_ASSETS/levelviewer" :)

I'll write up a proper guide on this before it goes to main.