-
Notifications
You must be signed in to change notification settings - Fork 457
MFRC522 NO read #2614
Replies: 3 comments · 3 replies
-
|
Please check the logs |
Beta Was this translation helpful? Give feedback.
All reactions
-
|
no errors in error log. and app log shows: For reader config key 'read_00': loading module 'rc522_spi' |
Beta Was this translation helpful? Give feedback.
All reactions
-
|
25.02.2026 21:26:08 - 41:daemon.py - jb.daemon - MainThread - INFO - Starting Jukebox Daemon (Version 3.6.0-alpha) |
Beta Was this translation helpful? Give feedback.
All reactions
-
|
Hi, did you connect all 8 pins (incl. IRQ) like described here? |
Beta Was this translation helpful? Give feedback.
All reactions
-
|
yes all 8 pins are connected and correct ports. defaults. and in installation i chose all the defaults as well . i just pulled out the multimeter again and they all are positive for continuity . my grnd is different than the image but that does not matter. |
Beta Was this translation helpful? Give feedback.
All reactions
-
|
re-installed with bookworm pre-release and it now works. after close to 20+ installs of bullseye |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
hey all . cant for the life of me get future3 to read from the MFRC522. As far as I know pins are correct. I run a separate python script to test the reader and the script reads the cards just fine,
Install: bullseye
Ras. lite 32 legacy.
i also have buttons on GPIO pins as well, They seem to work.
Is there something outside of the general install that i should be doing?
Beta Was this translation helpful? Give feedback.
All reactions