Feature Configurations

Hotkey Configuration

The AGBM includes the ability to assign "hotkey" button presses to whatever functions a user might want. There are four combinations by pressing L, R, and Start, along with either A, B, Select, or Up. When the four buttons are pressed simultaneously, they will trigger whatever feature they are connected to.

• If you bridge JP1 with solder (labeled "RST", on the back top right corner of the board), then pressing L + R + Start and Up will reset the system.
• A and B can be configured (independently) to either act as a normal trigger for external mods, or can be set up to replace a touch input seen on many display kits. If you populate the designated Z components (Z57, Z58, Z70, Z71) with the labeled capacitors, then you can solder a wire from the touch control on the screen kit to the ZA or ZB holes on the board. If instead the Z components are populated with resistors/jumpers, it can be used to interface with triggering external mods.
• The test point labeled "LR" (near the RST pads) corresponds to pressing L + R + Start + Sel. This does not do anything unless a user solders a wire to the LR point to control an external mod. This is kind of included for people to tinker with; you'll probably not need to do anything with it.