First of all, what a cool project.
I wasn't sure if I should re-open the last not working issue from Dutch, as it was closed, so I opted for opening a new issue, although mine is very similar.
Again, first of all, I'm not very experienced with electronics, but always eager to learn.
As you can see in the below image, not all segments of the clock are working as intended. Minutes work fine, every segments lights up if the time is right for it. But the hours aren't working properly, only one segment is lighting up:
Only 15 Segments of the clock are working, and no matter what I do, it always stays like that. I triple checked the connections, replaced pretty much all the segments with that one in the orange (violet) spot, but it will always only light up one of the hour segments of the clock.
LED-Strip is the same as you used, 3 LEDs per controller, so 9 LEDs per digit plus the one you mentioned to add extra for controlling brings the length to 87 in WLED app.
I went countless times over the schematics and redid them times and times again following your manual to the letter, but nothing changes. I also used several ESP32s and flashed each one a couple times, but again nothing changes.
I hope that you can direct me to the right solution.
Thank you very much in advance for your help.
Greetings Luther
First of all, what a cool project.
I wasn't sure if I should re-open the last not working issue from Dutch, as it was closed, so I opted for opening a new issue, although mine is very similar.
Again, first of all, I'm not very experienced with electronics, but always eager to learn.
As you can see in the below image, not all segments of the clock are working as intended. Minutes work fine, every segments lights up if the time is right for it. But the hours aren't working properly, only one segment is lighting up:
Only 15 Segments of the clock are working, and no matter what I do, it always stays like that. I triple checked the connections, replaced pretty much all the segments with that one in the orange (violet) spot, but it will always only light up one of the hour segments of the clock.
LED-Strip is the same as you used, 3 LEDs per controller, so 9 LEDs per digit plus the one you mentioned to add extra for controlling brings the length to 87 in WLED app.
I went countless times over the schematics and redid them times and times again following your manual to the letter, but nothing changes. I also used several ESP32s and flashed each one a couple times, but again nothing changes.
I hope that you can direct me to the right solution.
Thank you very much in advance for your help.
Greetings Luther