MeshT2 - Meshtastic Case for Heltec Wireless Tracker V2

This 3D printed kit is designed for the Heltec Wireless Tracker V2, featuring a magazine-style battery replacement design for quick 18650 battery swaps.

BOM List

1. 3D printed enclosure B1
2. 3D printed enclosure B2
3. 3D printed enclosure U1
4. 3D printed enclosure L1
5. 3D printed enclosure S1
6. 3D printed enclosure S2
7. 3D printed enclosure M1
8. 3D printed enclosure C1
9. 3D printed enclosure C2
10. Antenna
11. IPEX to SMA female adapter cable, 5cm length
12. Spring, wire diameter 0.3mm, outer diameter 2mm, length 10mm
13. Hex socket head cap screws M2x10 (4 pieces)
14. Hex flat head screws M2x4 (3 pieces)
15. AAA battery contacts
16. Terminal wires
17. Heltec Wireless Tracker V2
18. 18650 battery

The battery contact dimensions are shown in the image below, compatible size range: 9.0mm ~ 9.8mm

Assembly Instructions

Trim the terminal wires: red wire 10cm, black wire 1.5cm

Trim the battery contacts and flatten the protrusions on both sides

Solder the battery contacts to the terminal wires

Install the battery contacts into B1, requires glue for fixation

Assemble B1 and B2 using 2 M2x4 hex flat head screws

Assemble B2 and M1 using 1 M2x10 hex socket head cap screw

Install the SMA adapter cable to S1

Connect the SMA adapter cable and terminal wires to the Wireless Tracker V2, attach C2 to the Wireless Tracker V2

Install the Wireless Tracker V2 and battery contacts into L1, adjust cable positions

Install the spring and C1 to U1

Assemble U1 and L1 using 3 M2x10 hex socket head cap screws

Assemble U1 and S1 using 1 M2x4 hex flat head screw

Install S2

Install the antenna

Insert the battery

Assembly complete