Release 1.00

[Resinchem]

Initial Project Release

This is the first public release for this project. Please review the Firmware Documentation for installation, onboarding and configuration information.

Which File Should I Use?

Primary Controller

This is the main PRIMARY controller, connected to the LED strip(s). It may also have local wired sensors. A system will always have one, and only one, primary controller. The file used depends on whether you are performing a new install or updating and existing controller.

• Primary_Ctrl_vx.xx_Full.bin - Use for new installs. Erases all data on the ESP32 before flashing, including any prior configurations.
• Primary_Ctrl_vx.xx_Update.bin - Use to upgrade an existing controller. Prior settings and configurations are maintained.

Wireless Sensor Controller

This is firmware for creating WIRELESS SENSOR controllers. You may optionally have more than one wireless sensor... or none at all if you are opting for wired sensors connected directly the primary controller.

• Sensor_Ctrl_vx.xx_Full.bin - Use for new installs. Erases all data on the ESP32 before flashing, including any prior configurations.
• Sensor_Ctrl_vx.xx_Update.bin - Use to upgrade an existing wireless controller. Prior settings and configurations are maintained.

⚠️ALERT: Be sure you are installing the correct firmware onto the correct controller type! Installing the sensor firmware on a primary controller (or vice versa) will likely break your system and may require a full USB install to restore.

Breaking Changes

None: This is the initial release.

---

This discussion was created from the release Release 1.00.