This small board is designed to simplify and organize the wiring in your glider. A pair of terminals is provided for each device to be connected, one each for the device and the associated fuse. Up to 8 individual devices can be connected.
The board and terminals are designed for a much higher electrical load than should ever be needed in a glider, at least 10 Amps per channel and in total.
Integrating the board into the cabling is extremely simple. For each device to be connected, there is a terminal for the device itself and the associated fuse. This keeps the wiring harness simple and flexible; changes to devices or fuses do not require any adjustments to the circuits of other devices. The wiring is shown in the following diagram.
All terminals are easy to operate, just push the actuator with a little screwdriver and push-in or pull-out the conductor.
The terminals for fuses and devices are suitable for various types of wires:
- Solid concductor 0.2 - 1.5 mm^2
- Fine-stranded conductor 0.2 - 1.5 mm^2
- Fine-stranded conductor with ferrule 0.25 - 1.0 mm^2
The terminal for the main supply can handle conductors up to:
- Solid concductor 0.1 - 4.0 mm^2
- Fine-stranded conductor 0.1 - 4.0 mm^2
- Fine-stranded conductor with ferrule 0.25 - 2.5 mm^2
The half housing is 3D-printed and reliably protects against short circuits on the contacts on the underside of the board. With four mounting holes for M3 screws, the board can be securely and firmly mounted in the aircraft, with the screws fixing both the housing and the board at the same time.
Installation and use of the board are the sole responsibility of the user. The board has been built to the best of our knowledge and belief, but no warranty or guarantee can be given for correct functioning or interference immunity. The legal usability must be checked before each individual installation and, in case of doubt, clarified with competent and authorized personnel (CFS).
Copyright Fabian Schöttler 2023.
This source describes Open Hardware and is licensed under the CERN-OHL-P v2 or later.
You may redistribute and modify this documentation and make products using it under the terms of the CERN-OHL-P v2 or later (https:/cern.ch/cern-ohl). This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN-OHL-P v2 for applicable conditions
If you have any questions or suggestions about the board, please send an e-mail to fabian@schoettlerhome.de.
Electrical and PCB design by ScotteC
Housing design by Turbo87