Solaredge CCG-1000 gateway not supported yet

[LightBridge16]

hi,

First many thanks for all the work that you have put into this project!🙏🏻✌🏻.

I want to connect the Solaredge gateway CCG-1000 (Commercial Communication Gateway) over local network instead of logging into the monitoring server.

The problem is that the gateway is connected over the ethernet connection and modbus poort is set to 1502. I think the rs485 ID is 1 because everything is is connected on the RS485-1 the inverters
RS485-2 the Nodewatt meter with ID 2,
And RS485-E for the inverter with 2 Powerwalls 1 connected ID 24 & 25.

The problem is it will not find or connect to it over the local network.

[WillCodeForCats]

The CCG should be the same as connecting to an inverter after you enable Modbus.

Connect the Commercial Gateway to the Ethernet router and configure:
Communication -> Server -> LAN
Communication -> LAN Conf-> Set DHCP-> [Select Enable for DHCP or Disable for static IP config.]
If DHCP setting Disabled was chosen:
Communication -> LAN Conf -> Set IP -> [Set inverters’ IP]
Communication -> LAN Conf -> Set Mask -> [Set inverters’ subnet mask]
Communication -> LAN Conf -> Set Gateway -> [Set inverters’ gateway]
Communication -> LAN Conf -> Set DNS -> [Set inverters’ DNS]
Verify that the LCD panel of the CCG displays <S_OK>

Enable Modbus TCP under LAN Conf:

Source:

• https://knowledge-center.solaredge.com/sites/kc/files/commercial_gateway_installation_guide.pdf
• https://knowledge-center.solaredge.com/sites/kc/files/solaredge-communication_options_application_note_v2_250_and_above.pdf