Assembly Guide

Congrats on your brand new CorePad Lite! Lets get started with the basics!

How to Solder

Before we apply the solder we need to heat up the joint first as shown in Image A keep the iron on the joint while applying solder (Image B) make sure not to apply too much or too little or the contacts may short or not touch!
(Image A)
(Image B)

Building your kit!

Step 1

Great Now that we know the basics of soldering lets start by soldiering our SEED STUDIO XIAO RP2040 Headers and solder it to the board! (TM) (Image C)
(Image C)

Step 2

Now we Solder the switches to the board! It is recommended that you use tape to hold them in place before soldering! (Image D)
(Image D)

Step 3 The final bit!

Finally almost done! Now to solder the oled to the pcb!

Now Lets Flash Our Firmware!