Label with icons

[giodzilla]

Coucou,
it would be great to be able to print a icon (spoon, fork for cutlery, hex square for screwdriver bits ...) instead of a text on the label.

[andymai]

You can already do this. In the Label tabs section there's an icon picker next to each label's text. Right now there are about 30 icons, mostly fasteners and tools (hex key, drill bit, bearing, etc).

Nothing for cutlery yet. Spoon, fork, knife and a screwdriver bit would be easy to add. Anything else you'd want in that set?

[giodzilla]

You're right, i didn't see it before! wonderful
Spoon (little and big) ,fork, knife would be lovelly. This tool is amazing

[andymai]

Merged. Spoon, fork and knife are in, and the spoons come in two sizes: a teaspoon with a round shallow bowl and a tablespoon with a deeper one, so they read differently on the plate.

The set went a bit further than cutlery while I was in there. There is now a Kitchen group in the icon picker with spatula, whisk, tongs, ladle, chopsticks, bottle opener, peeler and rolling pin alongside those four, plus a screwdriver bit over in Tooling. It will be in the next release.