Sample markdown to compare two inverters or list all integration entities

[ivanfmartinez]

I'm installing two inverters and want to compare data between them

In my case I have named one inverter as lxp1 and other lxp2.

This code for a HA markdown card gets all entities from lxp1 and show side by side lxp2.

If you have different names, change the select and replace function calls

This can be adjusted easily for more inverters, or to show only differences

type: markdown
content: >+
  |entity|reg|lxp1|lxp2|

  |-|-|-|-|

  {% for entity in integration_entities('lxp_modbus') |
  select('contains','lxp1') | list | sort -%}

  {%- set entity2 = entity | replace('lxp1','lxp2') -%}

  |{{ state_attr(entity,'friendly_name') }}|{{
  state_attr(entity,'register_type') }}-{{ state_attr(entity,'register') }}|{{
  states(entity) }}|{{ states(entity2)}}|

  {% endfor %}



title: LXP Data

[ant0nkr]

Hi.
It's not always helpful and depends how you use inverters. I have 3 inverters connected in parallel 1 - master, 2 slaves and there is no need to compare values, since - they be always like on Master. Except, Grid sensors and Battery/EPS is you have independent batteries.

Thanks.

[ivanfmartinez]

Hi. It's not always helpful and depends how you use inverters. I have 3 inverters connected in parallel 1 - master, 2 slaves and there is no need to compare values, since - they be always like on Master. Except, Grid sensors and Battery/EPS is you have independent batteries.

Thanks.

Yes, comparision depends of the usage. But this make easier to compare. This helped to understand how some parameters work.

One that I found is the battery charging power, both inverters use the power configured on the master inverter and both charge at same time. The problem is that you configure X Watts on one inverter and in reality you charge at 2*X, after knowing this no problem on configuration.