Raspberry Pi Manual Setup Instructions

Jump to bottom Edit New page

WesGilster edited this page Jul 8, 2015 · 54 revisions

Raspberry Pi Installation

Install 2015-02-16-raspbian-wheezy.img onto an SD card. (I use Win32DiskImager) Do NOT use an older version!
Start your Raspberry Pi and type the following at the command line:

sudo raspi-config

Choose and enable the following options from the Raspberry Pi Software Configuration Tool:

Expand Filesystem
Enable Camera

Choose to reboot the Raspberry Pi when you are prompted by the configuration tool.
After the Raspberry Pi has completed rebooting, execute the following commands at the command line:

  sudo wget https://github.com/area515/Creation-Workshop-Host/raw/master/host/bin/start.sh
  sudo chmod 777 start.sh
  sudo ./start.sh

Automatically find your printer with the browseprinter client if you don't know the ip address and port of your Raspberry Pi. Or use your favorite browser and try:

http://[RaspberryPiIp]:9091

Optional Setup:

If you are setting up a dedicated wireless print server for your 3D printer, you can also run: raspi-config-cwhost.sh