Artisan Scope FC Timer

[3Chord]

Previously my roast logging would activate a count-down timer to FC. Upon logging the "dry-end" a small clock appeared by the FC at the top of the display and counted down, usually from the 3+ minute range. I used this to input changes to gas and fan speed that anticipated FC.

Must have changed a setting because all that appears is an estimated full time to FC from the Charge (in the 8-9 minute range). Hope this is making sense.

Does anyone know what setting panel activates the FC countdown timer? My hunch is this may be under "Phases" settings panel, but I can't get Artisan to make the change.

David

[poundy]

Config -> Phases. Do you have "Phases LCDs" enabled?

[3Chord]

Yes I do. I've attached a screen grab of the settings.

[MAKOMO]

The FC phase lcd is only active after the DRY END has been marked. By default it displays the estimated time into the roast the FCs will happen. A right-click on the LCD toggles it from this time estimate to the count-down timer, indicated by a small arrow pointing down before the label "FC".

[3Chord]

Hi Marko. Thanks for this info. I want to know if the change to FC countdown mode can be made permanent. In the past all my roasts showed countdown to FC after recorded DRY END. No need to right click - so I presume this feature was saved somewhere and thus was permanent. What is the procedure to return to what I had before? Many thanks.

David

[MAKOMO]

Put the Phases LCDs Mode for the Maillard phase to Temp. This is strange, but the 3rd LCD (FC) does display the count-down (and not the temp) in temp mode.

[3Chord]

Hi Marko. More information of value - so more thanks from me. I have included a JPEG so you can confirm I understood your instructions and made the correct adjustments.

David

[MAKOMO]

Correct!