Version 1.1

This is an "all fixes" release:

• Fixed low/no mic audio on startup in non-CW mode
• Properly store frequency offset value from tech mode menu item 82
• Start tech mode in PTT handkey so CW can transmit while tuning the frequency offset
• Resolve lingering tone transmission between and after CW elements
• Swap the TRS pins for correct dit/dah assignment by default

Thanks @rysiekuk for issue reports and code fixes!

v1.0.0

This is a first test of the GitHub action to build and publish versioned artifacts. I'll just keep re-publishing this release until I get it right, sorry for the noise.

"beta 3" -> v1.0.0

Changelist

• Merged up to F4HWN Fusion v5.5.0
• Pop reduction on CW/SSB TX
• VOX button now toggles B-KIN (break-in) mode when in CW
• Function - long-press 5 enters CPO keyer mode; F-long 4 cycles filters
• WPM range extended to 40 (was 30)
• SSB mode: disabled scrambler, compander, PTT-ID, CTCSS tail, and roger beep
• Improved menu text labels for CW-specific features
• Renamed CW input mode entries in the menu for clarity
• Initial CHIRP module based on F4HWN Fusion 5.5, adapted for NR7Y CW firmware
• Fixed side-1 button keying detection stall
• Updated K1/v3 paddle rework instructions

beta2

This release merges all of the CW features and fixes in the k5-v1 repo through the v1.0.1 release. I don't have the full GitHub actions working yet, so this is a manual binary post, but the repo code tag is matched.\

Note: The v3/k1 hardware will not be able to support the CEC cable. The microcontroller does not have the same analog features on the pins that made CEC possible. Button keying (PTT + Side1) is available, or follow the rework instructions to make the 3.5mm port compatible with a standard paddle cable connection.