You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Brian Keating edited this page May 24, 2016
·
1 revision
I have this motor controller. The page says it uses GPIO pins 5, 6, 12, 13, 22, 23, 24, and 25. They're using GPIO numbering -- in the board numbering system (RPii.GPIO.setmode(GPIO.BOARD)), these are pins 29, 31, 32, 33, 15, 16, 18, 22, respectively. These pins are therefore not available for other purposes when this controller is on the pi.
The motor driver node workspace/src/motor_driver/motor_driver subscribes to the motor_cmd topic, which is a message of type std_msg/Float32.