Firmware freezing on the Aquila H32 (Well, the Eryone Star One)

[tekjock]

I just tried latest HC32 build and shortly after I started it up it kept freezing and then would auto restart at times, most of the time i power off and on. Both mobo & Display firmware they installed fine, it was just as I was navigating around the display it would hang up

Before I get into this, let me explain the printer I have, I have the Eryone Star One, it is 100% a rebranded Voxelab Aquila X2. I will show some pics below.

From this build

• https://github.com/classicrocker883/MriscocProUI/releases/tag/2.1.3d-hc
  I tried the following BIN files
• HC32_Default-NP-ProUI.bin
• HC32-MM-ProUI.bin

and then from this display build

• https://github.com/classicrocker883/MriscocProUI/tree/2023-June/display%20assets/Aquila%20Display%20firmware
  I tired the 'Aquila Display firmware/Firmware Sets/DWIN_SET (Original)' version.

Here is a side by side comparison of this printers noticeable feature, my printer is on the right, the same shroud with the V, but just orange

Here are pics of the display board and mother board

[classicrocker883]

https://github.com/classicrocker883/MriscocProUI/releases/tag/2.1.3d-hc1

I posted an update. I have heard save mesh or Z offset may cause reboot. but everything else is fine, as far as I know.