Route duration not correct - routing problems

[MrHollowfield80]

Hi everyone,
I have the problem that Cruiser does not display the calculated route correctly. The route duration is not calculated and does not change the duration of the route does not correspond to the travel time by car or motorcycle. How do I set it so that the route duration is really calculated on the driving time?
And what is absolutely annoying is that the route is interrupted on the main road and Cruiser diverts me to residential areas and then back to the main road or highway. In addition, the route is simply interrupted in the town and redirected to 30 km/h zones for no reason. I have checked all the settings and adjusted the profile priorities. However, the changes have no effect on this route planning in 30 km/h zones

Thanks for any help.

[MotoUKRider]

@MrHollowfield80 The route through Dehnsen works fine here - using a 3-4wk old BRouter tile and then an update just now (to see if somebody tagged the road as "closed"). Your BRouter settings for the Section Profile would be useful to see.

My "Fastest" profile uses the following settings:
Avoid toll roads = Off
Avoid ferries = Off
Avoid motorways = Off
Avoid trunk roads = Off
Avoid primary roads = Off
Avoid secondary roads = Off
Avoid tertiary roads = 1
Avoid unclassified roads = 2
Avoid residential roads = 3
Avoid unpaved roads = On
Use gravel roads = Off
Ignore closed roads = On
Avoid cities = Off

[WolfgangZ42]

Setting Avoid residential road to 5/5 solves the problem.
My settings in the motorcycle profile:

. . .

[MotoUKRider]

@WolfgangZ42 Remember that the B3 is a "Primary" road, so in your settings, the avoidance level of 4 may have some bearing on this "generally". I know it's your "Curvy" profile, but if the routing algorithm takes the whole route as a whole number (say, 100) and then divides the routing between the "weighting" of the avoidances, it may just take you along a side-road "just for the heck of it" 😆

[devemux86]

@MrHollowfield80

About the route, it would be helpful if you could provide the route file and app profile,
so we can see your active routing settings and avoid strengths.

The route duration is provided by default in the calculated route by the routing service.
You can change this so that the route duration is calculated based on the average speed.

You can select the route duration mode and preferred average speed in "Settings | Routing | Advanced":