Skip to content
e2ret edited this page Aug 31, 2026 · 8 revisions

RNode — LoRa interface

RNode

The RNODE tab shows telemetry from the connected LoRa device (RNode) and lets you configure the radio channel parameters.

Telemetry

Metric Description
Airtime Percentage of channel time occupied by transmission
Channel Load Channel load (including other traffic)
Noise Floor Noise level in dBm. Lower is better for antenna positioning
RSSI Received signal strength
SNR Signal-to-noise ratio
Rate Current data transfer rate
Traffic Traffic statistics

Charts refresh every 10 seconds.

Connecting RNode via USB

RNode connects to the gateway via USB. To find the port, use System → Quick Commands → PORTS or over SSH:

ls /dev/ttyUSB* /dev/ttyACM*

Connecting RNode via Wi-Fi

Supported boards: Heltec LoRa32 v3, Heltec LoRa32 v4 (ESP32-S3).

⚠️ Heltec v2 only supports USB — Wi-Fi isn't available in the RNode firmware for it.

Wi-Fi mode setup:

rnodeconf /dev/ttyACM0 -N
rnodeconf /dev/ttyACM0 --wifi sta --ssid NETWORK_NAME --psk PASSWORD

After setup, disconnect USB and power it from a charger. RNode will connect to Wi-Fi. Find its IP in your router's client list.

In the Reticulum config (Configs), add the interface:

[[RNode-WiFi]]
  type = RNodeInterface
  enabled = yes
  port = tcp://RNODE_IP
  frequency = 869525000
  bandwidth = 125000
  txpower = 17
  spreadingfactor = 9
  codingrate = 8

⚠️ The Wi-Fi network must be 2.4 GHz. ESP32 doesn't support 5 GHz.

LoRa parameters

Frequency

In Russia, license-free bands are 433 MHz and 868–869 MHz.

Recommended value for 868 MHz: 869525000 (band center).

Bandwidth

Value Range Speed
125000 maximum low
250000 medium medium
500000 minimum high

Spreading Factor (SF 7–12)

SF Range Speed
7 minimum maximum
9 balanced balanced
12 maximum minimum

TX Power (dBm)

Maximum depends on the chip and local regulations. For SX1262, typically 17–22 dBm.

Diagnosing from telemetry

  • High Noise Floor (>-90 dBm) — interference; try changing frequency or repositioning the antenna
  • High Airtime (>50%) — channel is congested, consider changing frequency
  • RSSI < -120 dBm — weak signal, needs an antenna with better gain or positioning

Clone this wiki locally