You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository was archived by the owner on Nov 8, 2026. It is now read-only.
Thomas Nonis edited this page Oct 25, 2023
·
1 revision
The An2CAN is a small board designed to perform analog-to-digital conversion with direct forwarding to a CAN bus.
The concept of the An2CAN came about due to the necessity of adding multiple strain gauges on the suspension arms to measure the forces acting on them.
It has been designed to be as general purpose as possible, so that it can be also used to acquire other analog signals, such as APPS, BPPS, suspension springs travel, etc...
Front
Back
It has the following features:
4x input stages, each with either:
1x strain gauge ADC with quarter or half wheatstone bridge with optional offset
2x general purpose single-ended ADC
1x general purpose differential ADC
every stage has a separate and configurable:
gain
input voltage divider
input pull-up or pull-down
first order filtering
ambient temperature sensing
4-bit addressing to allow for a sharing a single firmware between multiple different boards
USB-C connection for both power and data (if CAN is not used)