You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository was archived by the owner on Nov 8, 2026. It is now read-only.
Thomas Nonis edited this page Oct 25, 2023
·
1 revision
Future improvements
In hindsight it might have been better to have two separate and specific devices: one for strain gauge acquisition and another for generic ADC. This would have allowed much smaller boards and to place the ADC stage right at the strain gauge without needing to route long cables that make the acquisition prone to noise distortion. On the flip side, this would have resulted in much more expensive boards (each of them would have required an MCU).
For the future, consider using the An2CAN as is for normal acquisitions and designing a second one dedicated to strain gauges. This second system would be made of multiple ADC stages that connect to a master (which could be the An2CAN as described here) to then perform pre-processing or DSP and then forward the data on a CAN bus. This solution would allow to use a single MCU on the master board, while leaving the front-ends and the ADC on low-noise slaves.