Device list including ID

[Pako2]

There are two K40RF/MX400 gateways in my device list. However, I only have one gateway physically connected. So I investigated why there are two in the list. I found out that one gateway has ID = 0x48 and the other 0x4B. I still don't know why it behaves like this. But I thought it would be useful if the device list also included the corresponding ID.

[proddy]

Thanks for mentioning this.

@MichaelDvP the gateways never have any entries and probably never will. Shall we remove them from the webUI only but still keep them as a device?

[MichaelDvP]

Maybe gray out the modules without entities and set the device-ID in brackets after Type, e.g. Thermostat (0x10) , Thermostat (0x38), Gateway (0x48), Gateway (0x4B)
But removing gateway is also a possibility, we have already excluded the controller.

[proddy]

Showing the device ID is quite technical, so I wouldn't show this. I'm trying to keep the webUI as simple as possible. If we grey it out, it'll still show 2 devices, which is confusing, to Pako2's earlier point. I suggest just remove it, only in the webUI.

[proddy]

implemented in core3, soon to be in dev

[bbqkees]

I would personally still shown them but greyed out or something, so you can at least see it's there.
Or show it, including the ID, when developer mode is active.
The K40RF is an important EMS bus member, as it is the Bosch internet module + RF transceiver for the remote valves etc.
Not showing it somewhere would probably confuse some users.

If excluded in the web UI it should still be included in the support file, we we can see it's there when troubleshooting.

[proddy]

Right now in core3 it's not shown in the WebUI at all. What I'll do is include it again, but grey it out, don't show the 0 number of entities and make it non-clickable. For the ProductID I could either include it in the Type column (e.g. Thermostat (0x10)) or use a tooltip so when the mouse hovers over it shows the ProductID, Version etc...

[proddy]

added in core3 - 3.9.0-dev.18