EMS-ESP hardware for hybrid heating system

[jheatb]

Hi everyone,

I'm considering buying an EMS-ESP gateway and would like to know if my Bosch hybrid heating system is fully supported.

My setup consists of:

Bosch Condens 9800i W (GC9800iW)
Bosch Compress 7400i AW
Bosch Hybrid Module HYC25
UI800 controller

I have a few questions:

Is the Condens 9800i W recognized by EMS-ESP?
Is the Compress 7400i AW recognized?
Does the HYC25 appear as a separate EMS device, or is it integrated into the boiler controller?
Is the UI800 detected?
Which entities/telegrams are available from each device?
Are hybrid-specific values available, such as:
active heat source (boiler / heat pump)
flow temperature (setpoint & actual)
return temperature
compressor status/frequency
boiler modulation
pump speeds
hybrid operating mode / bivalence information

If anyone has this exact (or a very similar) setup, I'd really appreciate a screenshot of the detected devices and available entities.

Also, if some of these devices are not yet supported, are there any plans or an estimated timeline for adding support in a future EMS-ESP release?

Thanks in advance!