Software setting : SSH

Option inside Shapextractor.ini:

 LPWM             Laser power intesity<br>
 CROPH            Set pixel need delete on from top for more clean output<br>
 QUALITY          Set scan resolution 0 (512steps/photos) 1 (1024 steps/photos) 2(2048 steps/photos)<br>
 ROT              Set position of camera 0 orizontal 90 vertical<br>
 CAMERA_HFOV      Set this to the camera lens angle that you worked out above.<br>
 CAMERA_DISTANCE  The distance from the camera 'foot' to the center of the turntable.<br>
 LASER_OFFSET     The angle between the centerline of the camera and the laser.<br>
 HORIZ_AVG        The number of consecutive horizontal points to average together to smooth out the surface.<br>
 VERT_AVG         The number of consecutive vertical points to average together to smooth out the surface.<br>
 A                gpio rpi for 1 in uln2003 (stepper)<br>
 An               gpio rpi for 2 in uln2003 (stepper)<br>
 B                gpio rpi for 3 in uln2003 (stepper)<br>
 Bn               gpio rpi for 4 in uln2003 (stepper)<br>
 LASER            gpio rpi for 5 in uln2003 (laser line) <br>
 LIGHT            gpio rpi for 6-7 in ulm2003 (light)<br>
 DELAY            delay from stepper sequence<br>
 FRAME_SKIP  <br>
 POINT_SKIP <br>
 RESW = 640       Set camera resolution<br>
 RESH = 480       Set camera resolution<br>