You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I probably tweaked something that did this, but I have an issue where on a print that isn't too close to the edge, the filament changes and then bumps the head in the X direction (overshooting X220?) and this causes the 2nd color to be off a few mm. I worked around it by rehoming on each filament change which is a pain. A small centered test print doesn't do this.
I noticed that my x stepper config has 220 as endstop but had a slightly larger number for position_max. Not sure if I did that or if it is stock, but setting max to 220 didn't help.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
Uh oh!
There was an error while loading. Please reload this page.
But in case anyone else is having this problem...
I probably tweaked something that did this, but I have an issue where on a print that isn't too close to the edge, the filament changes and then bumps the head in the X direction (overshooting X220?) and this causes the 2nd color to be off a few mm. I worked around it by rehoming on each filament change which is a pain. A small centered test print doesn't do this.
I intent do dig down deeper to see what is really happening but for now, this is working so I'm leaving it alone.
Video and code here: https://www.reddit.com/r/FlashForge/comments/1uputep/ad5x_color_misalignment/
I noticed that my x stepper config has 220 as endstop but had a slightly larger number for position_max. Not sure if I did that or if it is stock, but setting max to 220 didn't help.
All reactions