impossible to calibrate and get IMU signal ABX 00071

[samsab1]

hello
Hello everyone

I just flashed my arduino cc nano ble 33rev2 ABX 00071 with headtracker release 2.2. the flashing seems perfectly normal
the calibration phase seems to be going correctly, but I ultimately believe that it is never saved correctly although I ask for this calibration to be saved.

finally, the curves remain perfectly flat and smooth when I move the ARDUINO board. who could give me light?

bluetooth seems to be ok when connecting to https://headtracker.net/v22/

[samsab1]

[dlktdr]

Rev2 needs to use the development firmware and gui.

https://github.com/dlktdr/HeadTracker/actions/runs/10010869506
https://github.com/dlktdr/HeadTracker/actions/runs/9124117598

Bottom of each page is the artifacts(binaries)

You can find the most recent ones under actions. To upload the firmware, you have to select local file and use the extracted one from the firmware build

[samsab1]

many thanks for your answer.
so my ABX00071 remains usefull? but with an other firmware; right?

can you be more accurate in your answer, i m a newbie with arduino, and a french guy who is very not fluent in english.
do you mean that i keep the frontoffice software "headtracker 2.2" but i use the firmware

why did you give 2 links? how can i understand those 2 links?
best regards

[samsab1]

ok Cliff, it was so easy, thanks a lot , it seems to be ok
very best regards

[Aaronsss]

I have just ran into the same issue but dont seem to be able to resolve it with the above solution

It is a brand new unsoldered board but I presume that doesn't matter?

It looks like it's getting no data from the Arduino for the gyro or accelerometer during cal none of the values move for either accelerometer or magnetometer

[dlktdr]

I have just ran into the same issue but dont seem to be able to resolve it with the above solution

It is a brand new unsoldered board but I presume that doesn't matter?

It looks like it's getting no data from the Arduino for the gyro or accelerometer during cal none of the values move for either accelerometer or magnetometer

When you flashed it you picked the firmware labelled rev2?

You have the same abx00071 as well?

[Aaronsss]

Yes to both

[dlktdr]

Could you program a basic Arduino test program to it to see if the IMU is actually working on your board or if it's an issue on my end.

It might also help if you could put the a copy of what the serial monitor shows after a reboot of the board. Then put it in a text file and upload it here.

[Aaronsss]

I tried this script and get the following message over serial port https://docs.arduino.cc/tutorials/nano-33-ble-rev2/imu-gyroscope/

Started
Failed to initialize IMU!

Output from the serial port with the headtracker code
serial boot.txt

Broken board?

[Aaronsss]

A bit of further testing if I use Arduino_BMI270_BMM150 1.1.0 it gets a bit further but still does not enter if (IMU.gyroscopeAvailable()) {

Im guessing better checks were introduced from 1.1.1 onwards. It doesnt seem to want to come to life

[dlktdr]

Hmm yeah didn't detect it in this software either
[00065693] <err> htmain: Sense_Init failed according to that log.

• Also I guess I should add some more details to that error 😉. It's pretty vague

Kind of sounds like the baord. Can you post a close up photo of the board.

[Aaronsss]

Which ic is the imu? There is a part near the xyz logo that looks chipped. At first I thought it was an inductor but looks like a bga