[v0.4.0] feedback

Discussion thread for v0.4.0 release

---

What's new

• Updated slopkit with firmware 7.00–8.60 (poops) and 12.02–12.70 (p2jb) support, based on @soniciso1's pooP2JB
• Autoloader shortcut now skips the exploit and autoloads immediately if elfldr is already running (especially useful on p2jb after initial PC host install)
• Autoload now polls for elfldr readiness instead of waiting for a hardcoded 4s delay
• Internal improvements to kexp loading in slopkit

---

Setup Instructions - see README

[eiflax]

This is 10.00
The loading of this version is fast, more then previous version, only one 'placement message' into log.
But the first time I loaded obtained a KP after payloads messages are displayed. Need to load it more times to be sure about stability that at the moment best on this 10.00 was v0.2.1
The bug about ramdisk with host executable, persist on this version :(

Also I wanted to say about y2jb autoloader v0.9. I didn't test v.0.9.1 for obvious reasons. The last good autoloader version in 10.00 was v0.8. For some reason v0.9 KP the console most of the times when y2jb did exit to load the payloads with that unified loader new on v0.9. Also this version KP most of the times when lapse did fail, just when y2jb exits. I have tested a lot a fork that stay on y2jb when lapse is failing and KP is NEVER happening on that point.
I wanted to post this in a proper thread but I never saw something like this into y2jb autoloader section.

thx in advance

[priZrakinside]

itsPLK - Please add a check for whether the PlayStation 5 has already been jailbroken before starting the automatic jailbreak process.

If the console is already jailbroken, the auto-jailbreak tool should display a clear warning indicating that the system is already jailbroken and must not attempt to run the jailbreak again.

Running the jailbreak twice can very likely cause a kernel panic, so preventing a second jailbreak attempt would significantly improve stability and safety.

[DLazzzar]

Top container overall and time-left are frozen on 3.1% instead of being 60%

P2JB - PS5 Pro - 12.40

The bottom container time is properly shown.

Top container is just log. It logs whenever it goes to next p2jb phase. Might need to remove percentages/eta from there if that's confusing.