Repository navigation
Replies: 11 comments 12 replies
Post your configuration so we can see if there's anything not quite right. |
|
I cannot do direct valve control on Danfoss Ally (at least not as far as I know, but I am checking). |
|
From last few minutes.:. 2026-01-19 20:43:21.211 INFO (MainThread) [custom_components.versatile_thermostat.base_thermostat] VersatileThermostat-Spisestue Versatile Thermostat - find preset temp: boost |
|
Hello @jkbkster , You said it was working fine before 8.6.0 ? Can you confirm please ? Can you check in the VTherm UI Card the regulated temperature if the value is updated (it should greater than the setpoint in your case) : If you don't find anything, can you re-install the previous release and tell me if it works as before. I don't see any change on the 8.6.0 that could explain a change in the behavior of this part. |
|
Hi, I read nothing abnormal on the log. Spisestue Versatile Thermostat, regulated temperature is 2C above the target. I don't think it's a versatile thermostat issue. I see the valve open at 20% when heating is requested. I'm not sure but I think it's how your valve convert the target temperature into a valve position. Did you install an update on your TRV? |
|
Hello in 8.6.1 we introduce this fix "fix #1630 - [Feature Request] - Add expert option to deactivate the accumulated error division in case of error inversion (#1653)" by @bontiv. I don't see why this have change the behavior on your side. Are you sure you are not in expert mode ? Can you please install the 8.6.0 back and let us know. You have to force the release in HACS to get the 8.6.0. @bontiv , do you have kind of explanations ? |
|
Parameters of the strong mode is: kp: float = 0.4
ki: float = 0.08
k_ext: float = 0.0
offset_max: float = 5
accumulated_error_threshold: float = 50
overheat_protection: bool = TrueI see you are at accumulated_error 50 (max) and 1C of below. Can you make a graph with:
It will be usefull to help you. |












Uh oh!
There was an error while loading. Please reload this page.
None of my 9 rooms are reaching their temperature after 8.6.0 update.
Nothing apart from the update has been changed.
I just need the valves to open fully like before - now they only reach 20-30% .
What do I do ?
All reactions