Installation of micro-eBUS module on a Vaillant boiler and SensoComfort weather-compensated controller

[psqf]

Hi everyone, I’ve just installed the micro-ebus device to replace my (broken) Vaillant Connect. I requested the test token, and almost immediately, a host of entities appeared among the MQTT devices. However, most of them remain "unknown" until I manually trigger a read in the MESSAGES section or via polling. Looking at the log, I see the bus broadcasting about ten parameters every 10 seconds. Can anyone with a similar system confirm that I’ve set everything up correctly and that this is how it’s supposed to work?
Is it possible to request a sensor update directly from Home Assistant?
Thanks.
STATUS:

ENTITY:

BAI CONTROLS:

SENSORS:

POLL:

LOG:

(I’ve already asked John30 in private about this, but I think keeping the discussion public could be helpful for future users as well.)