Open
Conversation
Contributor
Author
|
Ordered A1 Mini Combo from MetatechTR, used wire transfer to save some money. Paid 17.863,25 ₺. |
Contributor
Author
|
I ordered the filaments, the prices had increased since the last time I looked. Also black petg was out of stock, ordered natural petg instead. 
|
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
1 participant
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
Introduction
This HEP proposes to buy our first 3d printer and a few spools of filament.
Pledging
This HEP accepts pledges. In the discussion #37 there are 11 upvotes to buy a 3d printer at the time of writing this, so let's put out money where our mouth is! 😄
Collected TotalRequired TotalBill of Materials
TotalPossible Q/A
Why BambuLab?
Easy to operate, plug and play, high quality prints. Also we have a few members who have positive experience using Bambu Lab printers.
Why A1 Mini?
It's cheapest Bambu Lab printer, silent, light-weight, do not compromise much from quality, entry-level.
Why A1 Mini Combo?
Multicolor printing for an additional 5400₺ sounds like a good improvement to me. Multi-color printing enables prints like rfid cards and badges with text and increases our overall capabilities. If you think we should not get the combo but instead get the A1 mini only (without AMS) let's discuss in the comments.
Why Porima?
Porima is slightly more expensive than the cheapest filaments available. It's consistently of high quality. It has a lot color options. When we use cheap filament, we usually waste filament because the prints fail more often and we throw away prints more often. Sometimes even we have to clean clogs from nozzles or AMS. Life is too short to deal with low quality filament.