Repository navigation
Virtual Networking
The Networking area manages the bridges your instances attach to, plus physical interfaces — with a live topology map of how everything is wired.

The page lists bridges and, below them, Network Interfaces: the host's physical ports and the VLANs and bonds built on them. In the bridges table, the Physical NIC column shows which port each bridge or NAT network uses, next to its negotiated link speed. In the Network Interfaces table, Physical NIC shows the real port a VLAN or bond runs on (followed down through any bridge, e.g. enp5s0 via vmbr0), and Model names the hardware (for example Intel Ethernet Controller X550), with the VLAN tag for VLAN rows. In the Networking sidebar mode, every bridge gets its own detail page with tabs for settings, attached instances, VLANs, and a per-bridge topology view.
Click + Create Bridge:
-
Managed bridge — Incus manages the bridge; assigning an IPv4 address optionally enables DHCP/NAT for instances behind it (be deliberate here: an address on a managed bridge starts a DHCP server on that segment; leave blank /
nonefor a passthrough L2 bridge) -
Enslave a physical NIC to bridge instances straight onto your LAN (like
vmbr0in the screenshot) — the portal refuses to steal a NIC that is currently carrying the host's own connectivity - VLANs — create VLAN interfaces on top of physical NICs and bridge onto them
The bridge editor shows all current settings when editing, so nothing is silently reset.
Bridges defined by the host itself (for example vmbr0 on the USB Appliance, or ones you created in /etc/network/interfaces) have a ⋮ menu with:
- Edit IP settings…: switch between DHCP and a static address, gateway and DNS. Set the address on the bridge, not on the port inside it.
- Apply now: brings the bridge down and up so the change takes effect without a reboot. If you are connected through it, reopen the portal on the new address.
Give only one interface a gateway; the portal warns you if you set a second one.
When virtualization is enabled, the portal creates one NAT network per connected port (host-nat, host-nat2, …) for guests that should sit behind NAT instead of on your LAN. The Physical NIC column shows the port each one leaves by.
Attach instances to any bridge from the instance's Edit dialog (VMs & Containers). The bridge page and the bridges table show the live count of attached VMs/containers.
The Topology map has a dedicated Networking Layer:

Switch layers with the buttons at the top of the map. The networking layer draws hosts, bridges, physical NICs, VLANs, and instance attachments; the storage & compute layer (shown above) draws shares → instances → datasets → pools → disks with live I/O. Both support zoom, fullscreen, dragging (positions are remembered), and hover cards with live metrics. Each bridge and each instance also has its own filtered topology tab.
- VMs & Containers — attaching instances
- Virtualization Overview — sidebar modes
Getting Started
Storage
- Dashboard & Monitoring
- Physical Disks
- ZFS Pools
- Datasets & ZVols
- MergerFS
- Snapshots & Protection
- File Sharing — SMB
- File Sharing — NFS
- iSCSI
- S3 Object Storage
- Capacity Trends
- Encryption
- UPS Management
Virtualization
Networking
Administration
Reference