RAK WisBlock 4631 reports incorrect temperature in telemetry starting with firmware v1.11.

[Emmpunkt]

Description:
My RAK 4631 is sending incorrect temperature values in the telemetry data. The reported temperature is consistently about 8°C higher than the temperature measured by the attached BME sensor.
This issue appears to start with firmware v1.11.0.
When I downgrade to v1.10.0, the temperature readings are correct again.
Observed behavior:

• Firmware 1.11.0 and newer → temperature is ~8°C too high
• Firmware 1.10.0 → correct BME temperature
• It looks as if the device is reporting the CPU temperature instead of the BME sensor temperature
  Question:
  Is anyone else seeing incorrect temperature readings with firmware 1.11.0 or later?
  Could there be a regression where the wrong sensor source is used?

[IoTThinks]

If there is BME sensor attached to the repeater, the temperature of the BME sensor will overwrite the temperature of the MCU temperature.

Do you see humidity and other telemetries of BME sensor?