Installation
Remove the following pin from the pinheader.
Install the pinheader to the mainboard
For 1.0 motherboards you will need to clear the solder on the vias with solder wick or desoldering pump/gun.
Install the wiring harness on the bottom side of the board.
I recommend securing the wiring harness to the mainboard with tape or uv resin Progto avoid snagging the pads or the wires ending up underneath a screw hole
Plug the wiring harness into the d0 connector on the modxo lite and attach it to the pinheader
Test boot the console and make sure it boots to PrometheOS
For 1.6 consoles you will need an LPC rebuild board which you can get here
Install the pinheader along with the LPC Rebuild board
Bridge the Lframe pads on the rebuild qsb
Snip the yellow wire from the wiring harness
Install the wiring harness on the bottom side of the board.
I recommend securing the wiring harness to the mainboard with tape or uv resin to avoid snagging the pads or the wires ending up underneath a screw hole.
Plug the wiring harness into the modxo lite and attach it to the pinheader
Test boot the console and make sure it boots to PrometheOS
