Skip to content

Hardware Setup

Jump to bottom
Nicolás de Ory edited this page Mar 27, 2020 · 3 revisions

(This should be better documented)

If you want to integrate the effects with an LED strip, you should have a NodeMCU board running WLED. You can find setup instructions here. Make sure you have done the following:

  • Enabled E1.31 in Sync Settings
  • Use E1.31 multicast -> Checked
  • E1.31 Start Universe -> 1
  • DMX Start Address -> 1
  • DMX Mode -> Multi RGB

Connect your PC to the same network as the NodeMCU board, and you should be good to go! As of now, the animations are optimized for a 170 LED strip, but they should work with different configurations.

Clone this wiki locally