⚡Please keep in mind that the board operates with high voltage. Do not touch the components!⚡
| Name | IO |
|---|---|
| T_1 | GPIO21 |
| T_2 | GPIO19 |
| T_3 | GPIO18 |
| K_1 | GPIO22 |
| K_2 | GPIO17 |
| K_3 | GPIO16 |
| RX | GPIO3 |
| TX | GPIO1 |
| RST | EN |
| BOOT | GPIO0 |
| Name | Description |
|---|---|
| AC IN | Power input for the board. (220VAC) |
| K* | Outputs for the relays.(default state: NC) |
| T* | 220V AC/DC signal inputs. |
Once you connected to the device or the device is in your LAN you can access it via the http://relay-controller.local url.
By default the device will act as an AP. If the AP isn't available (after 1 min from boot) the device will enter into AP mode.
- SSID: relay-controller
- password: 12345678
If you change the wifi please reboot the device.
Anonymous user has read access but can't change the config.
- username: admin
- password: admin
Changeable in the config tab.
- the LEDs of the K2 and K3 output is swapped.