Skip to content

Config (MQTT)

Jump to bottom
Victor Hayashi edited this page May 23, 2021 · 1 revision

In the config page, it is possible to set the homepage, change the WiFi credentials, the IP connection mode, obtain the device ID, and set the apPass (access point pass).

If no access point pass is set, the system disables the open access point after some minutes.

It is also possible to change the APMode (access point mode), and NTP configurations (servers, interval for syncronization).

The MQTT information (broker, port, and ID) are set in the bottom of the config page.

The IoT module publishes in the /pub topic, and is subscribed to the /sub topic.

Clone this wiki locally