Potential softlock caused by bad WiFi config

[zt64]

On my A5M pro I had setup a static IP address, which never had problems until today when my router assigned the same IP to another device, kicking my printer off the internet. In the printer's network settings, it was constantly spamming that it's connecting and failing to connect at the top of the screen. It completely blocked touch input so I wasn't even able to disconnect it from the WiFi in the UI. Even tapping repeatedly very quickly wouldn't get the UI to respond.

I was able to fix it through other means. It's a minor issue but the notification being spammed, blocking the UI input, could be a problem elsewhere too.

Would this be a KlipperScreen issue or an issue with the mod? I wasn't sure where to report so I just decided to make a discussion post so I don't report to the wrong repository.

[loss-and-quick]

Would this be a KlipperScreen issue or an issue with the mod? I wasn't sure where to report so I just decided to make a discussion post so I don't report to the wrong repository.

Klipperscreen is patched to work with iwd through dbus, so it is mod/patch problem