Connects on bluetooth, even performs homing, but joggle and any other control are locked

[natan098765432-source]

Hi, i followed your tutorial and bought a HC-06, set the baud rate to the default of grbl and connected it on grbl controller, but i could not joggle, send gcode, or anything really, but the communication was happening because I could send $H and it would home normally. It worked fine with otg cable for more than a Year.(sorry for my poor english)

[zeevy]

can you please post the console tab output

[natan098765432-source]

I sent "$H" and it homed, I sent "$X" and it did not unlock the jogle and commands, I sent "$$" and it answered with "$G" and "$#"
When I sent it to move with code($J=G91 X2 F600) it did move

Using the v1.1f (2017-08-01) Release

[natan098765432-source]

Tried using another board( a nano this time), and tried to change to grbl 1.1h and it acted the exact way

[natan098765432-source]

I just tried the first 1.1f release and nothing different, and I also tried another phone with an older an android, same results

[zeevy]

either firware is not supported ie you are not really on 1.1f

or

you wired the RX TX wrong, when connected console will show the machine info

wrong baud rate could also a problem

[natan098765432-source]

Sorry to have bother you, the problem is hc-06, its seems to be a clone, so when I sent AT+BAUD8 it went changed it to another weird and random baud rate, probably something close because it would send some codes, but not close enough for the app to work

I have tried to change its baud rate and I can't anymore, but the only responsive baud rate is 115200, but doenst work like it should

[zeevy]

May be you can try HC-05

[natan098765432-source]

Already tried one, it came faulty, would always be stuck at AT mode, my lucky with these modules are not great