Config Format

Config Format

All .cfg from Drop That (apart from drop_that.cfg) are loaded using a custom parser.

This results in some different behaviour than you would normally see in valheim config files.

• Detection of when settings are missing and when settings are empty.
• Warnings while parsing incorrect config files.
• Faster load time.
• No automatic comments for settings. Gotta go to this wiki now. Sorry.

Sections

[] are sections, that will contain all the lines following them, until the next section is reached.

• Eg., The section SomeSectionName will get the settings Line1 and Line2 assigned to it.

[SomeSectionName]
Line1 = Value1
Line2 = Value2

[SomeOtherSectionName]

Section Nesting

Sections can be "nested", by adding dots (.) to the section name. This will indicate the hierarchy they are in. This is also how Drop That makes lists.

Eg.,

[TopLevel]
Line1 = Value1

[TopLevel.LowerLevel]
Line1 = Value1

Means that TopLevel will have a single line, but also an extra section associated, which has its own line.

Whether or not a nested section can be used, and which names are valid, depends on the specic configuration file in question.

Section lines

Section lines always consist of a setting name, followed by a value. Eg.,

Setting1 = SettingValue`

If a setting is not added, Drop That will select a value for that setting in the following order:

• Other configurations (eg. ones done by other mods), if any are present.
• The original value for the entity being modified, if any is being modified.
• The default value for that setting

If a setting value is not specified, but the setting is:

Setting1 = 

Drop That will read that as a desire to revert existing configurations to the original. Eg., if a mod is configuring Drop That to give a drop a higher amount, adding a corresponding line without setting the value, will make Drop That remove that increased higher amount and use the original.

Decimal Numbers

Decimal numbers are always expected separated by .. That means 1/10 should be written as 0.1.

Comments

Comment lines can be added by starting with any of the following identifiers:

• //
• #
• --

Whitespace before it is ignored.

Eg.,

    # Some Comment
Setting=Value

Lines starting with any of these identifiers are skipped during parsing. Comments in same line as normal settings is not supported.

Eg., Setting1=Value # Some Comment will attempt to read Setting1 as Value # Some Comment, and not just Value.