User Setup for ESP32-S3 with Waveshare RPI ILI9486 and XPT2046 Touch controller

[wavoigt]

I modified "Setup11_RPi_touch_ILI9486.h" for working with ESP32-S3:

// For ESP32-S3
// See SetupX_Template.h for all options available
// ESP32-S3 + Waveshare TFT Configuration

#define USER_SETUP_ID 11

#define RPI_DISPLAY_TYPE
#define ILI9486_DRIVER
// #define RPI_ILI9486_DRIVER // 20MHz maximum SPI

// Important for ESP32-S3 !!!
#define USE_HSPI_PORT
#define TFT_SPI_MODE SPI_MODE0

#define TFT_MISO 13
#define TFT_MOSI 11
#define TFT_SCLK 12
#define TFT_CS   10  // Chip select control pin
#define TFT_DC   14  // Data Command control pin
#define TFT_RST   4  // Reset pin (could connect to RST pin)
//#define TFT_RST  -1  // Set TFT_RST to -1 if display RESET is connected to ESP32 board RST
#define TOUCH_CS 5     // Chip select pin (T_CS) of touch screen


#define LOAD_GLCD   // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
#define LOAD_FONT2  // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
#define LOAD_FONT4  // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
#define LOAD_FONT6  // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
#define LOAD_FONT7  // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:.
#define LOAD_FONT8  // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
#define LOAD_GFXFF  // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts

#define SMOOTH_FONT
#define SPI_FREQUENCY  20000000 // Some displays will operate at higher frequencies
#define SPI_TOUCH_FREQUENCY  2500000

Setup11_ESP32_S3_RPi_touch_ILI9486.h.txt