Cardwright v2.17.3 — custom card sizes

Custom card sizes

The Card size dropdown now ends with "Custom size…". Enter the printed
width and height in millimetres — 20 to 200 a side — and it's remembered,
appearing in the list alongside the built-in sizes from then on.

It drives the AI upscale target as well as the sheet layout, so set it before
you run the cards rather than after. If the grid you picked won't fit that size
on your page, the export says so instead of producing something wrong — use a
bigger paper or a smaller grid.

Reachable from the main window and from Export, since both show the picker.

Requested on r/mtgproxies.

Fixed

• Exporting a selection of sheets measured progress against the whole queue, so
  printing sheet 1 of a 90-card deck read "Placing card 3/90" while nine cards
  were going into the PDF. It counts what is actually being placed now. The PDF
  itself was always correct — only the message was wrong.

Downloads

• Cardwright.exe — portable, no install needed.
• Cardwright_Setup-2.17.3.exe — installer.

Existing installs will pick this up through the built-in updater.