1.4.1.6-1

Based on official firmware: U1_1.4.1.6_20260608141446

Official release notes
https://wiki.snapmaker.com/en/snapmaker_u1/firmware/release_notes/v141

Changes
Sync changes from paxx12 repo.
Corrected detection issue in 130+
Tweaked ace2 rfid to include subtype (u1 rfid app also tweaked for this)

MD5: BB9FA15C729A81623D395968BA56ACC6
SHA-1: F437C030DFC9B5343E1563A93EF1D95264A42A6A

1.3.0.168-4

Based on official firmware: U1_1.3.0.168_20260414155825

Official release notes
https://wiki.snapmaker.com/en/snapmaker_u1/firmware/release_notes/v130

Changes
v4
add Ace Pro 2 support

v3
Sync changes from paxx12 repo.
Removed the paxx12 openrfid changes as they messed up the rfid system holding the tags in memory
Added option in firmware config to force disable air printing detection.
Added the initial code for ace pro 2 but this is untested at this point

v2
Modify ace rfid code to read anycubic tags.
Sync changes from paxx12 repo.

v1
Apply paxx12-snapmaker-u1/SnapmakerU1-Extended-Firmware#394 130 changes.
Modify updater to work with major versions.

MD5: 4DBC486B17A89795D815611CA65B05D5
SHA-1: 67EA6A866035E467BE7AE344141723BDE369BB67

1.2.0.106-10

Based on official firmware: U1_1.2.0.106_20260323113459

Official release notes
https://wiki.snapmaker.com/en/snapmaker_u1/firmware/release_notes/v120

Extended firmware release notes
https://github.com/paxx12/SnapmakerU1-Extended-Firmware/releases/tag/v1.2.0-paxx12-14

Changes
v10
Fix code error on rfid reading.

v9
Fix code error on rfid disable option.
Add option to set rfid detection for all spools to generic vendor for snapmaker orca with default filaments.

v8
Modified entangle detect for both modes during printing.

v7
Merged changes from the original extended firmware repo. v1.2.0-paxx12-14
Changed feed logic for direct connect mode, the ace will wait until the user runs loading mode to load the filament to the toolhead.
Modified feed speed detect for feeder mode during loading.
Modified entangle detect for feed assist mode during printing.
Modified updater to include paths and fallback.
Added option to disable the U1 RFID readers on the sides of the printer while using ace.
Added macros for fluidd/mainsail to start and stop the ace dryer.

Moved all mods to ramdisk so no modifications are made to the extended firmware klipper install, disabling the mods will stop them being loaded into the ramdisk on boot.

v6
Added updater for the ace mod to the firmware-config menu to allow the ace mod to be updated without needing to reinstall the entire firmware.

MD5: DEA0AE87FB124BDAA2753D780952F05A
SHA-1: D7AEF35B6A9382FB4495EA947AE631BB57D08C51