Layer Rescue 0.2.2

Fixed

• Restarted (manual) mode printed in the air after a power cycle. Z is not homed at that point, so absolute G1 Z moves did not match the aligned nozzle and the bed dropped (about 11 mm in the reported case). Every Z move is now written as a relative move from the aligned position, so the result no longer depends on G92 Z or on the Z the firmware believes it is at.

Changed

• Restarted mode turns off soft endstops (M221 X0 Y0 Z0), as the stock P1S start G-code does.
• Travel moves that also change Z are split: lift before travelling, lower after travelling.
• Restarted mode rejects sources it cannot convert safely: conditional firmware blocks that change Z, G92 Z, and extruding moves that change Z.