Neewer-Bridge v1.0.0

First versioned release. Everything below is the state of the project as of
this date — hardware-validated on a five-light fleet (2× TL120C, TL60 RGB,
TL21C, TL97C) deployed on Linux/BlueZ.

Core bridge

• ArtNet (ArtDmx) → Neewer BLE bridge: UDP listener, DMX channel mapper,
  one coalescing actor per configured light (run, the default command).
• Deterministic binding by MAC address — mapping is independent of
  power-on / discovery / connection order.
• Per-light DMX profiles: cct, cct_gm, hsi, rgb (R/G/B→HSI, the
  openHAB-friendly default), rgbcw (native 5-ch passthrough), full,
  advanced (10-ch mode-select: CCT/HSI/FX/RGBCW/XY bands), pixel
  (20-ch, 8-segment colour + 5 effects).
• Protocol drivers: classic 0x78 (incl. MAC-addressed Infinity frames,
  selected per model via cmd_type), Neewer Home 0x7A. Encoders byte-exact
  against the decompiled NEEWER Studio app; 100+ unit tests.
• 141-model capability catalog (models.toml) extracted from the app;
  add auto-identifies a light and fills driver/profile/CCT range.
• Reliability: connection-health probing with recycle-on-failure, jittered
  reconnect backoff (no fleet-wide reconnect storms), write coalescing at a
  capped flush rate, on-demand duty-cycled discovery scanning (kind to cheap
  adapters), ArtDmx sequence tracking (stale-packet drop), configurable
  failsafe (hold/blackout/poweroff).
• Configurable logging: console + size-rotating file sinks with per-sink
  levels; startup logs the version, the loaded config path, and each light's
  profile/channel span.

CLI

• run (default), scan, add (interactive blink-to-identify or scripted),
  test (guided one-frame probes, --status, --colors, --modes,
  --pixel, raw: spelunking), ota (firmware flashing over the custom
  0x78 block protocol — check-code validated, no-brick by construction),
  lights, models, adapters, inspect, monitor, artnet-send.
• --version prints the release; the version is also the first startup
  log line.