Rad Pro 3.0.2: Release #303
Replies: 8 comments 17 replies
-
|
Note: An error has been fixed that prevented using the web installer to update Rad Pro 3.0 and 3.0.1 on GQ GMC-800 devices. |
Beta Was this translation helpful? Give feedback.
-
|
Not sure why, but anything higher than 2.1.1 gives me really messed up fonts on Fnirsi GC-01 |
Beta Was this translation helpful? Give feedback.
-
|
I just upgraded a friend's GC-01 to 3.0.2. It would not take the image from the bootloader at all. I had to solder in the header and use an StLink. That wasn't fun. I HATE ROHS SOLDER! Anyhow, I immediately noticed the rather primitive looking fonts. It looks like 3.0.2 does not anti-alias the fonts whereas 2.1.1 does. Attached are shots of my friend's 3.0.2 unit and my 2.1.1 unit. Aside from the graphical downgrade, 3.0.2 seems to operate normally on the GC-01 WCH CH32F103 which is what both units are running. Both are also running J321 GM tubes. |
Beta Was this translation helpful? Give feedback.
-
Working,...... |
Beta Was this translation helpful? Give feedback.
-
|
Does anyone know why the date and time set on my GC 01 resets to factory value when i shut down my GC? |
Beta Was this translation helpful? Give feedback.
-
|
Hi, I hope I got it right. I have a problem with my GC-01 after uploading this version of the software, namely, after a few moments the counter starts to squeak automatically, a blinking red bell is displayed, and in the lower left corner there is a DAMAGED inscription. And now I don't know what to do with it (I went back to the original software version 1.5). My arrangement is |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.







Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
It is my pleasure to announce the release of Rad Pro 3.0!
Bosean FS-600/Bosean FS-1000/Bosean FS-5000 users: This release requires an update with an ST-LINK V2 USB dongle.
Updates:
This discussion was created from the release 3.0.2 "Icebreaker".
Beta Was this translation helpful? Give feedback.
All reactions