OpsLog v0.50.5

Changelog

• chore: release v0.50.5
• fix(ui): drop the guessed floor — the measurement is the floor
• fix(ui): measure what the stats panel needs instead of guessing a floor
• feat(map): say what the SOLEIL figure on the map card is
• fix(settings): no "Saved" flash under the FlexRadio per-band table
• fix(ui): the entry row gets a height floor, so widgets stop scrolling
• test(cluster): pin a spot's tenth of a kHz end to end
• fix(telemetry): the once-a-day heartbeat is sent every day
• fix(motorant): the docked antenna widget fits its dock again
• fix(motorant): the track-mode select leaves the docked widget
• feat(motorant): tracking on/off and its step in the docked widget
• feat(entry): a typed frequency takes its mode from the band plan
• fix(bandplan): the last segment's "to" can be typed in the table
• feat(rotor): show the elevation beside the azimuth
• fix(ui): the detail tabs keep their width when a keyer is running
• feat(easycomm): ask the way the controller wants to be asked
• fix(yaesu1000): the frequency bytes were going out backwards
• fix(ui): the title bar keeps its frequency readout
• fix(ui): the window buttons cannot be pushed off the screen
• fix(udp): the entry stops holding a call the decoder has already logged
• fix(audio): a device you chose and that is absent is an error, not a swap
• fix(audio): the talk-into-the-rig path says why it is silent
• docs(audio): the two buttons say they act on this PC
• fix(remote): the audio log names the device, not its GUID
• fix(yaesu): OFF switches off, without asking
• fix(cat): the trace switch exists for every backend that has a tracer
• feat(yaesu): ON / OFF on the console, and a console to press it from
• fix(awards): the corrected county list reaches existing installs
• fix(awards): Alaska is four counties for USA-CA, not twenty-nine
• fix(yaesu): the CAT wire trace never covered this backend
• feat(remote): the position sees what the radio is being fed
• fix(remote): receive audio was hostage to the transmit device
• docs(audio): say which two devices the remote uses at each end
• fix(remote): "none / system default" means the system default
• fix(icom): a filter change keeps the radio in its data mode