AB9 Active Shifter 0.10.0

Warning

This drives a 12 Nm active force feedback device, at your own risk. A defect, an
unlucky combination of settings or a stalled loop can make the base shake, kick or
drive to its stops without warning, which can injure you and damage hardware. Forces
start off and are capped at 10% until polarity is measured - raise the gain slowly,
keep clear, and know where the power switch is. There is no warranty of any kind and
nobody is liable for injury or damage: see LICENSE and NOTICE.md in the zip.

Note

Unofficial. Not affiliated with, endorsed by or supported by MOZA, SimHub or vJoy.
Early software, in active development, built and tuned against a single base on a
single firmware revision.

Install: close SimHub, copy AB9ActiveShifter.dll from the zip into
C:\Program Files (x86)\SimHub\, start SimHub and enable it under Settings -> Plugins.
Setup and tuning are in the README, which ships in the zip.

What's Changed

• Stop claiming the stock shifter mode has no effects, because it has two by @Gugic in #5
• Surface the WallRamp safe ceiling on the Feel tab, because SlotRamp()… by @NervouZ1 in #6
• Surface the ChannelFreeDepth safe ceiling on the Feel tab, matching item #1's treatment by @NervouZ1 in #7
• Add per-slider undo and a modified-since-profile-opened marker to the Feel tab by @NervouZ1 in #8
• Add a percent-of-column-spacing display toggle for the lateral geometry dials by @NervouZ1 in #9
• Add a live-tracking force curve for the slot detent, and a plain-language explanation by @NervouZ1 in #10
• Add Gate Walls, Sliding Across The Gate, and Slot Mouths visualizations by @NervouZ1 in #11
• Give the shipped gate real release hysteresis, and stop a graph re-deriving the gate by @Gugic in #12

New Contributors

• @NervouZ1 made their first contribution in #6

Full Changelog: v0.9.0...v0.10.0