Warning
This drives a 12 Nm active force feedback device, at your own risk. A defect, an
unlucky combination of settings or a stalled loop can make the base shake, kick or
drive to its stops without warning, which can injure you and damage hardware. Forces
start off and are capped at 10% until polarity is measured - raise the gain slowly,
keep clear, and know where the power switch is. There is no warranty of any kind and
nobody is liable for injury or damage: see LICENSE and NOTICE.md in the zip.
Note
Unofficial. Not affiliated with, endorsed by or supported by MOZA, SimHub or vJoy.
Early software, in active development, built and tuned against a single base on a
single firmware revision.
Install: close SimHub, copy AB9ActiveShifter.dll from the zip into
C:\Program Files (x86)\SimHub\, start SimHub and enable it under Settings -> Plugins.
Setup and tuning are in the README, which ships in the zip.
What's Changed
- Stop a mistyped tunnel pair from commanding a full-scale reversal, and watch for a base that has stopped producing force by @Gugic in #13
- Read the clutch off its own pedal, make the bite point a first-class fact, and put profile switching on a hotkey by @Gugic in #14
- Close the two holes where the gate promised something it did not deliver by @Gugic in #19
- Draw the gate at the size the geometry makes it, so a dial has a picture by @Gugic in #17
- Make the effect-loss warning true before making it act by @Gugic in #18
- Add a car-model auto-switcher for profiles, and hide the lockout-only geometry field on patterns without one by @NervouZ1 in #16
- Keep the car auto-switcher off the telemetry path until someone asks for it by @Gugic in #20
Full Changelog: v0.10.0...v0.11.0
