AB9 Active Shifter 0.9.0-rc3

Warning

This drives a 12 Nm active force feedback device, at your own risk. A defect, an
unlucky combination of settings or a stalled loop can make the base shake, kick or
drive to its stops without warning, which can injure you and damage hardware. Forces
start off and are capped at 10% until polarity is measured - raise the gain slowly,
keep clear, and know where the power switch is. There is no warranty of any kind and
nobody is liable for injury or damage: see LICENSE and NOTICE.md in the zip.

Note

Unofficial. Not affiliated with, endorsed by or supported by MOZA, SimHub or vJoy.
Early software, in active development, built and tuned against a single base on a
single firmware revision.

Install: close SimHub, copy AB9ActiveShifter.dll from the zip into
C:\Program Files (x86)\SimHub\, start SimHub and enable it under Settings -> Plugins.
Setup and tuning are in the README, which ships in the zip.

What's Changed

• Land changes through pull requests, and say so where agents will read it by @Gugic in #1

New Contributors

• @Gugic made their first contribution in #1

Full Changelog: v0.9.0-rc2...v0.9.0-rc3