Ubuntu Desktop 22.04 Jammy with Kernel 6.1.62

Here is a pre-built image with Ubuntu Jammy Desktop for the NanoPi R5S.
The config userdata.txt is also attached

• Kernel Headers are pre-installed.

The username and password is ubuntu

It's based on:
Linux Kernel: 6.1.62
U-Boot: 2022.07

(The extracted Archive is around 9GB big)
Credits go to @pyavitz and his debian-image-builder

Debian 11 Bullseye with Linux Kernel 6.5

This Pre-Built Image is built on:
u-boot-rk3568_2023.07.02
linux-image-rk3568_6.5.0

The username and password are both: debian
This release contains the kernel headers, the image and the userdata.txt from the build.

The changelog for 6.5 includes for the Rockchip:
-RK356x – Support for RGA block # This should enable VPU HW Acceleration
-PCIe controller driver:
Remove writes to unused registers
Write endpoint Device ID using correct register
Assert PCI Configuration Enable bit after probe so endpoint responds instead of generating Request Retry Status messages
Poll waiting for PHY PLLs to lock
Update RK3399 example DT binding to be valid
Use RK3399 PCIE_CLIENT_LEGACY_INT_CTRL to generate INTx instead of manually generating PCIe message
Use multiple windows to avoid address translation conflicts
Use u32 (not u16) when accessing 32-bit registers
Hide MSI-X Capability, since RK3399 can’t generate MSI-X
Set endpoint controller required alignment to 256
...

the whole Arm Changelog can be read here

Credits go to @pyavitz and his debian-image-builder

Debian 11 Bullseye with Linux Kernel 6.1

This Pre-Built Image is built on:
u-boot-rk3568_2022.07
linux-image-rk3568_6.1.52

The username and password are both: debian
This release contains the kernel headers, the image and the userdata.txt from the build.

Credits go to @pyavitz and his debian-image-builder

[Does not work] Debian 11 Bullseye with FriendlyArm 6.1 Vendor Kernel

This Pre-Built Image is built on:
u-boot-rk3568_2022.07-1
linux-image-rk3568_6.1.25-1 from https://github.com/friendlyarm/kernel-rockchip

and was made with: pyavitz/debian-image-builder

The username and password are both: debian
This release contains the kernel headers