Joycon2Android 1.1.0

Eden support: motion, buttons and sticks all set up in one tap, plus a warning when there aren't enough DSU slots to go round.

What's new

• Eden gets one-tap setup. Pick Eden in the DSU card and press Set up — buttons, both sticks and motion are all mapped for you, so no manual binding in Eden's own controller screen.
• A warning when the four DSU slots run out. Players past the fourth, or a pair with no room for its second hand, are now called out on the card instead of silently going unmapped.
• Auto setup stops hiding. The emulator picker and Set up button are always visible in the DSU panel, and tell you Shizuku is missing when you press them, rather than vanishing without explanation.
• "0 connected" made sense of. The DSU card counts emulators, not Joy-Cons, so it now says it's waiting for one instead of reporting zero while your controllers are in hand.

Upgrading

Re-run Set up on the DSU card for your emulator — this release writes bindings the old config doesn't have. If the emulator is open the app will offer to close it; let it, or the write is discarded.

ARMS players: Eden's controller applet overrides the Joy-Con pair with a Pro Controller, which hides the thumbs-up grip. Setting the controller applet to LLE for ARMS works around it.

Install

Download joycon2android-1.1.0.apk below and install it over your existing copy. See the README for the full setup guide.

Notes

• SYNC is required for every connection — Switch 2's button-press reconnect is console-exclusive at the link layer and can't be reproduced through Android's BLE API.
• Not affiliated with, endorsed by, or sponsored by Nintendo. The BLE protocol was reverse-engineered by the community; this project contains no Nintendo code. See the credits.